Installation Checkout
Checkout Procedure When the installation is completed, verify your work using the Programmer’s
Reports. In addition, do the following:
.
Test point status changes
.
Test common annunciation
.
Interrogate the system about point and node information
l
Test common trouble point status reports and responses
Use Version 8.0 1 (or later) of the 4 100 Programming Unit to make any corrections.
When the system responses are satisfactory, perform the following task for each
remote Graphical LED Annunciator:
l
Replace the retainer and retainer holding screws. (See
ZnstalIution,
“Mounting
the Retainer.“)
31
To Next Page
Loading...
