Simplex 7100 User Manual

KAA1158 0108
7. With the door open, enter your new combination. Depress each button fully and release
it. You must feel a click each time you press a button to know that the button was
fully depressed.
8. Turn the outside thumbturn to the right (clockwise) until it stops; the latch/bolt
should retract.
9. For automatic relocking latches, release the outside thumbturn and the latch should return
to its initial extended position.
For manual relocking deadbolts, turn the outside thumbturn to the left (counterclockwise)
until it stops; the bolt should extend.
Keep the door open and test the operation of the lock 2–3 times to make sure your combination was
set correctly.
Note:
• Donotuseexcessiveforceatanytime.
• Ifawrongcombinationisenteredwhileoperatingthelock,turntheoutsidethumbturntothe
left (counterclockwise) to the top position and release (see Figure 2). This will clear any
previously depressed buttons. Enter in the correct combination.
Troubleshooting
Symptom/problem: Turning outside thumbturn clockwise always retracts latch without depressing
any buttons.
Cause: Lock is in zero combination.
Solution: Follow the procedure for setting a new combination except omit step 2.

Simplex 7100 Specifications

General

Brand	Simplex
Model	7100
Category	Locks
Language	English