10. Remount the front lock assembly by aligning the lock-in studs of the mounting bracket with the mating
holes of the front lock assembly lock-in plate.
11. Turn the control key to the left (counterclockwise) to the vertical position. The front lock assembly is now
locked in place.
12. Enter the new combination and rotate the turn knob to the right (clockwise) and hold. Make sure that the
panic device latch is fully retracted; then release the turn knob.
Note:
Do not use excessive force at any time.
If a wrong combination is entered while operating the lock, turn the outside thumbturn to the left
(counterclockwise) to the stop position and release. This will clear any previously depressed buttons. Enter in
the correct combination.
Troubleshooting
Symptom/problem: Turning outside thumbturn clockwise always retracts latch without depressing any
buttons.
Cause: Lock is in zero combination.
Solution: Follow the procedure for setting a new combination except omit step 2.
To Next Page
Loading...
Need help?
General
