8. Turn the control knob to the right (clockwise) to the stop position and release to activate the new
combination (see figure 4).
9. Enter new combination and test operation before reassembly.
10. Replace the "tamper proof" button head screw back into the front escutcheon plate with the special
combination change tool provided.
Note:
Do not force at any time.
If a wrong combination is entered while operating the lock, turn the outside thumbturn to the left
(counterclockwise) to the stop position and release. This will clear any previously depressed buttons. Enter in
the correct combination.
Troubleshooting
Symptom/problem Turning outside thumbturn clockwise always retracts latch without depressing any buttons.
Cause: Lock is in zero combination.
Solution: Follow the procedure for setting a new combination except omit step 2.
To Next Page
Loading...
Need help?
General
