[Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may be a
ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting procedures
outlined at bottom of this document for a zero code symptom/solution.]
6200 Series FAQ
Changing the Code / Combination
For your security the combination must be changed when the lock is installed. Perform this procedure with the
door open.
The factory-set code is 2 and 4 depressed simultaneously release, followed by 3 release. This code should be
changed as soon as the lock is installed.
1. Turn the thumbturn to the left (counterclockwise) to the stop position and
release. This will clear any random entries from the mechanism.
2. Enter the existing combination.
3. Gently remove the rubber cap (A) covering the combination change hole and
save (see figure 1).
4. Insert the pointed end of the spanner wrench (B) into the combination change
hole as shown (see figure 2).
5. Gently lift up until a slight click is heard or felt. Do not force.
6. Remove the spanner wrench.
7. Turn the outside thumbturn to the left (counterclockwise) to the stop position
and release to clear the old combination.
8. Select a new code and write it down (some or all of the buttons may be used
for your new code, depressed individually or simultaneously). Each button may
be used only once.
9. With the door open, enter your new code. Depress each button fully and release. A slight click should be
felt as each button is depressed.
10. Turn the thumbturn to the right (clockwise) to the stop position and hold.
The latch should retract (see figure 4).
11. Release the thumbturn.
To Next Page
Loading...