[Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may be a
ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting procedures
outlined at bottom of this document for a zero code symptom/solution.]
7000 Series FAQ
Changing the Code / Combination
Important: The following steps must be performed while the door is be open.
The factory pre-set combination is 2 and 4 pressed simultaneously and released, then press 3 and release.
Read the instructions through once before attempting to change the combination.
1. Turn the outside thumbturn to the left (counterclockwise) until it stops then
return it to the right (clockwise) slowly to the horizontal position and release.
2. Enter the existing combination.
3. Insert a Phillips-head screwdriver into the central piece of the combination
change assembly (see figure 1). Gently turn the screwdriver to the right
(clockwise) until it stops. A slight click should be felt. Do not force.
4. Remove the screwdriver from the combination change assembly.
Important: When removing the screwdriver, the central piece must return to its
initial position, if not, set it back to its original position using the screwdriver
(see Figure 1). If the central piece of the combination change assembly does not
return to its original position, the combination will be cancelled and the lock will
jam.
5. Turn the outside thumbturn to the left (counterclockwise) until it stops and
return it slowly to the right (clockwise) to the horizontal position and release.
This clears the existing code (see figure 2).
6. Select a new combination and write it down. Some or all of the buttons may
be used for your new code, pressed individually or simultaneously. Each button
may be used only once. We do not recommend the use of a one-button
combination.
7. With the door open, enter your new combination. Depress each button fully and release it. You must feel a
click each time you press a button to know that the button was fully depressed.
8. Turn the outside thumbturn to the right (clockwise) until it stops; the latch/bolt should retract.
To Next Page
Loading...