Simplicity 2691128-00 User Manual (English)

Questions and Answers:

C
Carlos DavisAug 16, 2025
Why Simplicity Lawn Mower engine will not turnover or start?
- D
  daniellawrenceAug 16, 2025
  Several factors can prevent your Simplicity Lawn Mower engine from turning over or starting. It could be due to the brake pedal not being fully depressed, requiring you to fully depress it. Other potential causes include an empty fuel tank (allow the engine to cool before refilling), a discharged or dead battery (recharge or replace it), or loose/broken wiring (visually inspect the wiring, and consult an authorized dealer if frayed or broken). Faulty components like the solenoid, starter motor, or safety interlock switch can also be the reason, as well as water or old gas in the fuel, in which case you should consult an authorized dealer.
P
pbrooksAug 22, 2025
Why Simplicity 2691128-00 cut is uneven?
- V
  Vanessa KirkAug 22, 2025
  An uneven cut with your Simplicity Lawn Mower may be due to the mower not being leveled properly; level the mower deck. Also, check that the tractor tires are properly inflated.
K
kmurphyAug 25, 2025
What to do if Simplicity 2691128-00 engine stalls easily with mower engaged?
- T
  thomastylerAug 26, 2025
  If your Simplicity Lawn Mower engine stalls easily when the mower is engaged, several factors could be responsible. Ensure the engine speed is set to full throttle. Avoid fast ground speeds. You might also need to service a dirty or clogged air filter. If the cutting height is set too low, especially in tall grass, raise it to the maximum for the first pass. Allow the engine to warm up for several minutes before engaging the mower, and start the mower in a cleared area to reduce initial strain.
C
Candice OdomAug 27, 2025
Why Simplicity 2691128-00 engine runs, but tractor will not drive?
- R
  ronaldariasAug 27, 2025
  If the engine runs but your Simplicity Lawn Mower won't drive, make sure the ground speed control pedals are depressed and the transmission release lever is in the DRIVE position, not PUSH. Also, ensure the parking brake is disengaged. If these steps don't work, the traction drive belt may be broken or slipping, in which case you should see an authorized dealer.
E
Emily DaughertyAug 30, 2025
What to do if Simplicity Lawn Mower engine knocks?
- T
  Thomas MillerAug 30, 2025
  If your Simplicity Lawn Mower engine is knocking, it might be due to a low oil level. Check the oil level and add oil as needed. Also, ensure you are using the correct grade of oil, consulting the Oil Recommendations Chart for guidance.
N
nataliebrownSep 1, 2025
Why Simplicity Lawn Mower cut is rough looking?
- Z
  zmyersSep 2, 2025
  A rough-looking cut from your Simplicity Lawn Mower could be due to the engine speed being too slow, so set it to full throttle. Alternatively, the ground speed might be too fast, so slow down. If the problem persists, the mower may have another issue, and you should consult an authorized dealer.
M
Mark VargasSep 4, 2025
Why Simplicity 2691128-00 Lawn Mower engine exhaust is black?
- M
  Michael BarkerSep 4, 2025
  If the engine exhaust from your Simplicity Lawn Mower is black, the air filter is likely dirty. See Servicing the Air Filter section.
B
barrettjessicaSep 7, 2025
Why Simplicity Lawn Mower excessive oil consumption?
- R
  Ruben KelleySep 7, 2025
  Excessive oil consumption in your Simplicity Lawn Mower can occur if the engine is running too hot, in which case, see an authorized dealer. Using the wrong grade of oil (see Oil Recommendations Chart) or having too much oil in the crankcase can also cause this problem; drain any excess oil.
J
Joshua FrySep 10, 2025
What to do if Simplicity 2691128-00 Lawn Mower engine starts hard or runs poorly?
S
susan01Sep 10, 2025
Why Simplicity 2691128-00 tractor steers hard or handles poorly?