Simplicity 5/14, 8/14

Questions and Answers

S
Spencer PinedaJul 30, 2025
Why won't my Simplicity Chippers/Shredders engine start?
- D
  dbrownJul 30, 2025
  If your Simplicity Chippers/Shredders engine won't start, here are a few things to check: * Make sure it's not out of gas; add gas if needed. * Ensure the spark plug wire is connected. * Verify that the engine controls are correctly set and adjust them if necessary. * Inspect the spark plug; if it's fouled, remove, clean, and replace it. If these steps don't resolve the issue, it could be a compression or electrical system problem, and you should consult your local dealer.
K
Kevin CohenAug 3, 2025
What to do if my Simplicity 5/14, 8/14 Chippers/Shredders makes unusual noise or vibrates a lot?
- T
  Timothy JohnsonAug 3, 2025
  If your Simplicity Chippers/Shredders is making unusual noises or vibrating excessively, consider the following: * The rotor might be overloaded; allow the unit to clear itself before adding more material. * There could be non-organic material in the shredding chamber; shut down the machine and remove any foreign objects. * The chipper knives might be dull or loose; sharpen or tighten them securely. * Hammers might be broken, bent, or loose; check their assembly and replace if necessary. * Hammers might be frozen on the shaft; check for obstructions and remove debris from the hammer pivot areas. If the problem persists, the crankshaft might be bent and you should see your local dealer for factory authorized repair.
Z
Zoe MillerAug 8, 2025
How to fix a Simplicity 5/14, 8/14 Chippers/Shredders vacuum that is not working?
- M
  madisonbakerAug 8, 2025
  If the vacuum on your Simplicity Chippers/Shredders isn't working, try these steps: * Ensure the hopper lid is properly in place. * If the material is too wet, allow it to dry. * Make sure the hose is correctly attached according to the kit instructions. * Inspect the hose for obstructions or damage; repair or replace as needed. * Set the throttle to 'Fast'; if the problem continues, consult your dealer.
E
Erin NguyenAug 14, 2025
What to do if my Simplicity 5/14, 8/14 Chippers/Shredders rotor turns but no material is discharged?
- M
  Mark ButlerAug 14, 2025
  If your Simplicity Chippers/Shredders engine runs and the rotor turns, but no material is being discharged, check the following: * The discharge chute may be clogged; clear it. * The engine might not be running at full RPM; adjust the throttle to 'Fast'.
M
Michael LarsonAug 18, 2025
Why is there excessive branch vibration when chipping with my Simplicity Chippers/Shredders?
- B
  Bradley KingAug 19, 2025
  Excessive branch vibration when chipping materials with your Simplicity Chippers/Shredders may be due to: * Dull chipper knives; sharpen or replace them. * Extremely hard or dried-out tree limbs and branches; these are too hard for chipping and should be used for firewood instead.
C
Caitlin KingAug 25, 2025
What causes the rotor to not turn when the engine runs on Simplicity 5/14, 8/14?
- M
  maurice73Aug 25, 2025
  If the engine runs but the rotor doesn’t turn on your Simplicity Chippers/Shredders, it could be that the crankshaft key is broken or not installed. Replace the crankshaft key.