7 Transmission Repair
7C Tuff Torq K60
7 - 62
56. Remove the spring from the motor shaft.
57. Remove the thrust ball bearing assembly. Inspect the
bearing for wear or damage.
58.Remove the snap-ring, washer, bearing and seal
from the motor shaft. Replace seal before assembly.
59. Inspect the motor shaft for wear or damage. Replace
if necessary.
Figure C–55. Disassemble Motor Shaft
60. Remove the five pistons, washers and springs from
the pump cylinder block.
61.Inspect the cylinder block and pistons for wear or
damage. Replace if necessary.
NOTE: Be careful not to damage the cylinder block or
the center case. If either is damaged, the center case,
pump cylinder block and motor cylinder block should be
replaced as a set.
Figure C–56. Disassemble Pump Cylinder Block
To Next Page
Loading...
