7 Transmission Repair
7D Hydro-Gear 0750 / 0800
7 - 84
13. Place a jack under the transaxle. Remove the axle
mounting bolts from the left and right side of the
frame.
Figure D–8 Remove Mounting Bolts
Figure D–9 Remove Transaxle
14. Lower the transaxle to ground making sure that the
mounting straps and linkages clear the frame.
15 Remove all external components from transaxle
case:
• Brake Arm
• Brake Actuating Pins
• Hydrostatic Control Arm
• Cooling Fan (if not previously done)
• Input Shaft Pulley
• Bypass Valve Actuating Lever
• Case Vent Hose
• Frame Mounting Hardware
To Next Page
Loading...
