FRONT-TO-BACK LEVELING
6. Arrange the blades so they face front-to-back.
7. Measure the distance from the ground to the front tip
of the center blade, and from the ground to rear tips
of left-hand and right-hand blades.
Front tip of the center blade should be 1/4" (6mm)
higher than rear tips of left-hand and right-hand
blades. If not, proceed with Steps 8 - 9.
8. 44” Mowers - To raise front of mower deck, loosen
front nut (A, Figure 32) and turn rear nut (B) against
bracket. To lower front of mower deck, loosen rear
nut (A) and the bracket will move backwards to
lengthen rod.
46” and 52” Mowers - Loosen the outside nut (A,
Figure 33). Turn the eccentric nut (B) to raise or
lower the front of the mower. When the mower is
level, hold the eccentric nut while tightening the
outside nut.
9. Re-check the blade measurement then tighten the
front nut against the bracket to secure.
Figure 33. Front to Back Leveling (46” & 52” Mowers)
A
B
MAINTENANCE
30
Figure 32. Front to Back Leveling (44” Mowers)
B
A
To Next Page
Loading...
