Simplicity SOVEREIGN 3416S - Fluid Level Checks; Tire Pressure Check

Figure 26. Creese zerk located inside right wheel hub-
LOC ATI ON
ILLUSTRATION
Left Tie Rod End
Right Tie Rod End
Front Axle Pivot
Power Take Off Pivot
Figure 21, Item E
Figure 24 r Item C
Figure 23, Item A
Figure 29, Item A
CHECK TIRE PRESSURE: Tires wihlast longer and
perform better if they are kept properly inflated. They
should be inflated as follows. Front tires 12 to 15 PSL Rear
tires 6 - fl PSI.
CHECK TRANSMISSION OIL LEVEL: See figure
30. Remove pipe plug (A) to check the oil level in the axle
housing. Oil should he level with the bottom of the threads.
If it is not, add SAE 90 weight transmission oil. Replace
the plug and tighten it securely.
Figure 27, Grease zerk on right rear axle.
Figure 23. Front of tractor showing axle pivot.
If it should be necessary to drain the axle housing, the drain
plug is located at (B). Always tighten it securely when replac¬
ing to prevent oil leakage.
CHECK BEVEL GEAR BOX OIL LEVEL: See
figure 31. The check and fill plug for the bevel gearbox is
located at (A). Remove it to check the oil leveL The bevel
gear boot is properly filled when oil is visible at the bottom
of the elbow. If filled to the top of the elbow, oil may be
forced out the vent plug located on top of the bevel gear
housing. If oil is required, add SAE 90 weight transmission
oil. Fill only until oil can be seen in the bottom of the pipe
elbow. If it should be necessary to drain the bevel gw hous¬
ing, the drain plug is located at (B), Always tighten it se-
uiety when replacing to prevent oil leakage.
Figure 29. Power take off Idler pulley, pivot points as seen
from beneath tractor.
17