To Next PageTo Next Page
Need help?Do you have a question about the Simply Brands MS-PH68-SS and is the answer not in the manual?
Instructions on what to do if you smell gas, including shutting off supply and contacting services.
Rules regarding storing flammable vapors, liquids, and LP cylinders near the appliance.
Guidelines for outdoor or ventilated area placement and surface area requirements for ventilation.
Warning about improper installation causing injury or damage; emphasizes reading instructions.
Rules for installing, operating, and maintaining the LPG cylinder and appliance, including ventilation and hose checks.
Requirements for LPG cylinder dimensions (31.8cm diameter x 58cm tall) and maximum capacity (15kg).
Warnings against indoor use, use on vehicles/boats, and altering the unit.
Emphasizes qualified service for installation/repair and regular inspection of the gas system.
Detailed steps for leak checks using soap solution and warnings against open flames.
Guidelines on not moving while operating, cooling down, keeping ventilation clear, and avoiding painting.
Keeping flammable materials away, supervising children, and ensuring guards are replaced.
Proper positioning of hose/regulator, checking seal fit, and avoiding ventilation obstruction.
Closing gas valve, checking hose monthly, and storing cylinders in ventilated areas.
Warning about small batteries causing choking hazards and keeping them away from children.
Heater is for outdoor use only; maintain 100cm clearance from top and sides to combustibles.
Heater must be placed on level firm ground and anchored against strong winds.
Never operate in areas with gasoline or flammable liquids/vapors.
Use only propane, butane, or mixtures; conform to local codes for installation and handling.
Never use damaged tanks; ensure proper vapour withdrawal and avoid unregulated connections.
Perform a soap solution check at installation site; heater must be checked with a full cylinder.
Ensure safety valve OFF, turn gas ON, and re-check fittings if leaks are found.
Never leak test while smoking; turn off gas supply if a leak is detected.
Step-by-step guide to lighting the pilot and setting the variable control knob for operation.
Instructions for turning off the pilot and the main gas supply valve.
Procedures for closing gas valve, removing regulator/hose, and storing cylinders safely.
Wipe surfaces with a soft, moist rag; avoid combustible or corrosive cleaning agents.
Remove debris from burner; use a protective cover when not in use.
Diagram identifying key parts like Reflector, Flame Screen, Glass Tube, and Supports.
Key dimensions of the heater, including width (650mm), base width (730mm), and height (2270mm).
Describes it as a transportable heater with gas cylinder housing, steel casing, and heat emission from reflector.
Details on gas types (propane, butane), pressure, and wattage (6.8kw - 14kw).
Outlet pressure of the regulator for different appliance categories and gas types.
Lists injector sizes for main and pilot burners based on appliance category and gas type.
Lists necessary tools for assembly, including screwdriver and soap solution for leakage test.
Identifies and lists major parts like Reflector, Flame Screen, Glass Tube, Supports, and Panels.
Detailed list of all hardware parts with quantities, organized by part letter.
Visual identification of hardware like wing nuts, screws, washers, and bolts with quantities.
Lists specific tools like wrenches, fixing brackets, and the optional long stem lighter.
Details about the required AA battery for the appliance, noting it is not included.
Steps to attach the wheel assembly to the bottom plate using bolts and flange nuts.
Instructions for loading the battery and securing the control box assembly to the upper support.
Steps to fix the block belt to the lower support behind the front door using screws.
Instructions for attaching the upper supports to the lower support using screws.
Securing the flame screen to the upper support using screws.
Attaching the reflector to the flame screen using studs, washers, and wing nuts.
Guide to installing the glass tube with the black silicone ring into the upper and lower plates.
Hanging protective guards onto supports and securing them with fixing brackets and screws.
Instructions for attaching the three side panels to the heater using screws.
Steps to install the knob, hang the chain, and connect the front panel to the bottom plate.
Connecting the gas hose and regulator to the gas cylinder, ensuring hose safety.
Detailed instructions and warnings for performing annual leak tests using soap solution.
Visual guide showing areas to check for leaks at hose/regulator and regulator/cylinder connections.
Lists probable causes and solutions for the pilot light failing to ignite.
Lists probable causes and solutions for the pilot light extinguishing after ignition.
Lists probable causes and solutions for the main burner failing to ignite.
General| Brand | Simply Brands |
|---|---|
| Model | MS-PH68-SS |
| Category | Patio Heater |
| Language | English |
