SimplyHome Motion Sensor SH003B Page | 1
Motion Sensor – SH003B
User Manual and Installation Instructions
Product Summary
The SimplyHome Motion Sensor (SH003B) should be installed in any indoor location where motion detection is needed.
The enclosed unit is a passive infrared sensor that detects movement within a specific area by sensing the infrared energy
emitted from a body as it moves through the sensor’s field of view. When operating, the system will operate as a part of
a wireless mesh network. This network allows the sensor to transmit signals to other sensors within the network or to a
system base unit. Additionally, the main unit contains a temperature sensor for readings wherever the sensor is
mounted, and it also contains a tamper switch for alerting when the sensor has been opened.
Powering On the Device
To power on the SimplyHome Motion Sensor (SH003B) take the following steps:
• Remove the cover on the main unit. To do so, gently pry the top and bottom housing apart at the line around
the unit.
• Locate the battery holding area (as seen in the picture above).
• Insert the enclosed battery per the directions noted on the plastic enclosure (positive terminal should be closest
to the green LED Light above). After inserting the battery properly a green LED Light should turn on momentarily
above the battery.
• Put the two plastic covers back together and be sure that they snap completely closed.
To Next Page
Need help?
General