Simpson Strong-Tie Quik Drive Pro Series

Questions and Answers

C
Christopher WilsonAug 3, 2025
What to do if screws don't advance properly in my Simpson Strong-Tie Quik Drive Pro?
- J
  Jessica HallAug 3, 2025
  If screws aren't advancing properly, ensure you're using only Quik Drive brand collated screws. Check and reset the depth adjustment on the attachment if needed, and ensure you haven't missed the substrate. Insert the screw strip correctly, pointed end first. Lift the tool completely off the work surface after driving each screw, and avoid dragging screw strips. Also, check that the feed pawl assembly is intact and the feed lever is engaged.
A
Austin PhillipsAug 12, 2025
Why won't screws drive and just spin with my Simpson Strong-Tie Power Tool?
- A
  Andrew ColemanAug 12, 2025
  If screws won't drive, spin briefly, and then fall, ensure the screwgun isn't in reverse. Check that you're using the correct bit for the screw type. Also, inspect the bit for wear and replace it if necessary.
Q
qthomasAug 25, 2025
What to do if Simpson Strong-Tie Power Tool screws won’t drive completely and the bit spins out?
- A
  Alexandra WhiteAug 25, 2025
  If screws drive halfway and the bit spins out, first ensure the screwgun isn't in reverse. Then, verify you're using the correct bit for the screws. Finally, check the bit for wear and replace it if needed.

Summary

Quick Start Instructions

Driving Screws

Ensure screwgun is in FORWARD. Start screwgun before applying pressure, continue until screw is driven.

Loading Screws

Insert screw strip pointed end first. Push release lever to unload.

Setting Driving Depth

Adjust depth by pressing the release. Test in scrap material for optimal setting.

Tool Grip and Angle

Maintain a correct grip and hold the tool at a 90° angle for proper driving.

Troubleshooting Guide

Problem: Screws Wont Drive

Screws fail to drive, spin for a second, fall over, or show little penetration.

Problem: Incomplete Screw Driving

Screws drive halfway then bit spins out, indicating potential bit wear or technique issue.

Problem: Countersinking Issues

Screws are almost driven but won't countersink, likely due to depth adjustment or substrate miss.

Problem: Tool Jamming

Screws don't advance properly, causing the tool to jam, possibly due to screw type or loading.

Operating Instructions

Attach Adaptor to Screwgun

Connect the Quik Drive adaptor to your screwgun, following manufacturer's instructions for secure attachment.

Install Correct Bit

Ensure the correct bit is installed. Remove old bit using release key and insert new bit until it snaps.

Connect Attachment to Screwgun or Extension

Insert mandrel, slide attachment on, and push until locking lever snaps. Rotation is adjustable.

Attach Extension to Screwgun

Loosen clamp, insert screwgun with adaptor, push tight, and tighten thumbscrew.

Load Screws

Insert screw strip pointed end first until they click in place. Push release lever to unload.

Set Driving Depth

Press DEPTH RELEASE to adjust. Test in scrap material to achieve optimal setting.

Adjust Handle Height

Adjust the handle to a comfortable and ergonomic height for operation.

Maintenance and Warranty

Changing Non-Skid Teeth

Nibs can be reversed by prying them off and sliding them onto the front of the nosepiece.

Changing Hex Mandrel

Remove retaining clip and washer, then slide the mandrel through the front nosepiece.

Limited Lifetime Warranty

Applies to Quik Drive products, free from defects if stored, maintained, and used properly. Excludes normal wear.