Simpson Hybrid Prolite - Page 5

DRIVEN BY SAFETY TEAMSIMPSON.COM 5
DRIVEN BY SAFETY
DRIVEN BY SAFETY
VISIT TEAMSIMPSON.COM TO SEE THE
FULL LINE OF HEAD AND NECK RESTRAINTS
OR CALL 800.654.7223
With the 2012 mandates in effect, the Simpson Hybrid Pro has endured stringent testing to
prove that it is the safest option on the market. As part of Simpson’s SFI 38.1 certifi ed line of
Head and Neck Restraints, it was designed with the lowest profi le for maximum comfort and
maneuverability. Expertly engineered by Trevor Ashline with Safety Solutions technology,
it provides the quickest entry and exit from the race car and is NASCAR approved. From the fi rst hit to the
last, the Hybrid Pro gives you every advantage.
With the 2012 mandates in effect, the Simpson Hybrid Pro has endured stringent testing to
prove that it is the safest option on the market. As part of Simpson’s SFI 38.1 certifi ed line of
Head and Neck Restraints, it was designed with the lowest profi le for maximum comfort and
maneuverability. Expertly engineered by Trevor Ashline with Safety Solutions technology,
it provides the quickest entry and exit from the race car and is NASCAR approved. From the fi rst hit to the
CERTIFIED
IN KICKING ASS
AND
TAKING IMPACTS
AND
TAKING IMPACTS
AND
MULTIPLE ANGLE IMPACTS ACTUALLY, AND A LOT OF THEM.
4 TEAMSIMPSON.COM TOLL FREE 800.654.7223
ANCHOR INSTALLATION
Gently pry helmet liner away from shell using a blunt instrument. See Figure 7
Insert the nutwasher inside the helmet against the shell using a wrench. Align with hole. Insert
post through the cap, spring and base and screw into nutwasher. Tighten until the point of the
post faces 40 degrees downward. Use a 7/16” (11mm) wrench to hold the post anchor outside
of the helmet in position and tighten from inside.
See Figure 8
Tighten 1/4 turn beyond snug. The ats and slot of the post anchor should be at a 40 degree
angle and the point of the post should face the rear of the helmet.
Gently pry helmet liner away from shell using a blunt instrument.
See Figure 7
Insert the nutwasher inside the helmet against the shell using a wrench. Align with hole. The
M61 Quick Release Helmet Anchors are handed, the pin opening needs to be pointed toward
the back of the helmet on each side. The anchor needs to be angled downward from the
helmet at about 40 degrees down. With this orientation, the Simpson logo should be level on
the side of the helmet. When tensioning the screw, hand tighten until secure and then add
an additional ¼ turn to tension. Attach the Velcro patch provided to the front chin bar of the
helmet and attach the end of the release tether to it. **Refer to page 15 for picture
SAFETY NOTE Simpson recommends using thread locking uid when assembling helmet anchors.
*REFER TO YOUR SANCTIONING RULES FOR HELMET INSTALLATION.
Final Steps - Helmets without holes and pre-drilled helmets.
POST ANCHORS
M61 QUICK RELEASE ANCHORS
Figure 6
Figure 7
Figure 8