3
6) Drill the helmet using a 3/16” drill at the point marked in step 5.
7) Clean the hole in the helmet as much as possible.
Put a medium strength locker on the Nut-Washer and place it
on the inside of the helmet over the hole.
Thread the screw from the outside of the helmet trough the D-
ring and into the helmet and Nut-Washer. Tighten the helmet D-
ring screw snuggly. Over tightening is not necessary and could
damage the helmet shell.
Hybrid X Front Tether Installation & Adjustment
This is only used in the “X” Version of the Hybrid
1) Use the mounting hole location of the
visor to find the center of the helmet 1”
up from the bottom of the helmet.
2) Next, measure & mark 2” over from the center of the helmet 1” up and
drill the helmet with a 3/16” bit. (Measurement may have to be adjusted
3/4” up for some helmets).
To Next Page
Loading...