Upper Limit
Lower Limit
E. Turn the engine
ignition switch and
the fuel valve to their
ON positions.
G. Adjust choke as needed.
CLOSED OPEN
NOTE: The starting position of the choke will
vary depending on the engine temperature. If
starting a cold engine, move the choke lever
towards the closed position. If starting a warm
engine, move the choke lever towards the
open position. Once the engine warms up
from running, you may need to adjust choke
towards the open position until idle is smooth.
F. Slide the throttle to run.
H. Pull the recoil slowly until resistance
is felt, then pull rapidly to start the engine.
I. Slide the throttle to slow.
J. Turn the engine ignition switch to the OFF position
Page 3 of 3 REV 3 - 4/21/2022
Part Number 7117648 / English
Copyright 2022. All Rights Reserved.
Assembly:
The trash pump was shipped from the factory
without oil in the engine. Running the engine
without oil will result in severe engine damage
and void the warranty. To avoid causing engine
damage and voiding the warranty, ll the
engine with the recommended oil type before
starting.
1. Place the trash pump
on a level surface then
remove the engine oil
dipstick by unscrewing it.
2. Fill the engine
with the correct
oil per the engine
owner’s manual.
The oil level should
be towards the
high mark on the
dipstick. Replace
the dipstick when
the engine is full.
NOTE. The suction and discharge hoses are not included. Assemble them as per the manufacturer instructions.
Full
3. Remove fuel cap, ll fuel tank with fresh
gasoline, then replace fuel cap.
NOTE: Fill with engine o and cool. Do not
over ll fuel tank.
Engine Oil Dipstick
Starting:
A. Place the trash pump on a level surface.
B. Completely immerse the strainer but do
not allow it to rest on the bottom of the water
source.
C. Do not exceed the maximum suction
head and total head lifts as sepecied for
your trash pump.
NOTE: The suction head lift should always
be less than the discharge head lift.
D. Remove the primer funnel cover and ll
the pump with water. Thread the cover back
on.
Fill the engine with oil and gasoline:
Thread the strainer barb (3) into the strainer
(4). Slip the hose clamp (2) over the end of the
suction hose (1) (not included). Slide the end
of the hose over the strainer barb then tighten
the clamp.
Shutdown:
To Next Page
Loading...