Step 1
Remove both wall channels from the door frame. Place each wall channel in position on
the tray (10 - 15mm in from the outer edges of the tray), use a spirit level to ensure they
are vertical and mark all 8 xing holes onto the walls (holes inside).
Drill holes in the positions marked using a 6mm masonry drill bit. Insert wall plugs (C)
into all of the holes (beyond the thickness of the tile). Fix the wall channels to the wall
using 8 x 38mm screws (B) and push on the screw covers (D).
Note: Inject silicone sealant into the holes before inserting the screws to seal the holes.
Insert the pent panels into the wall
channels and position correctly on the tray.
Note: The drain slot running across the
top and bottom of the pent panels MUST
be on the inside of the enclosure.
Warning: Take care, the pent posts are
not xed to the pent panels.
Step 2
PIVOT DOOR PENTAGON
3
Step 3
Insert the door into the pent posts
positioned on the pent panels.
Pent posts
Step 4
Before xing the door and pent panels
to the wall channels and pent posts
you must make sure that the door is
square within its outer frame.
First, centre the door between the pent
posts. Next, with the door closed the 4mm
gap between the bottom of the door and
the frame MUST be parallel all the way
across. If the gap is not parallel, push the
top of the door frame to the left or right so
the door hangs squarely within its outer
frame.
4mm
Ø 6mm
To Next Page
Loading...