Simpsons SUPREME - Step 5: Fix Pent Panels to Door and Channels; Step 6: Fit Brace Bar

Step 5
4
Once you have checked that the door opens and closes correctly
and the pent posts are vertical, x the pent panels to the wall
channels and pent posts and x the door to the pent posts.
From inside, drill 3 holes through each wall channel into the pent
panels (in the marked positions) using a 3.5mm drill bit.
Note: Stop drilling as soon as you feel the drill break through the
rst 2 layers of aluminium. Fix using 6 x 10mm screws (A) and
push on the screw covers (D).
Check again that the pent posts are vertical, and drill 6 more
holes through each pent post into the door and pent panels (in the
marked positions) using a 3.5mm drill bit.
Note: Stop drilling as soon as you feel the drill break through the
rst 2 layers of aluminium. Fix using 6 x 10mm screws (A) and
push on the screw covers (D).
Ø 3.5mm
Ø 3.5mm
Pent
panel
Pent
panel
Step 6
Fit the brace bar (F). Position the brace
bar in the corner with one end on the pent
panel and the other against the wall. Use
a spirit level to ensure it is level and mark
the screw hole positions onto the pent
panel and wall.
Drill a hole in the position marked on the
wall using a 6mm masonry drill bit. Insert
a wall plug (C) into the hole (beyond the
thickness of the tile). Drill a 3.5mm hole
in the position marked on the pent panel.
Note: Stop drilling as soon as you feel the
drill break through the rst layer
of aluminium. Fix the brace bar to the wall
using a 38mm counter sunk screw (H).
Note: Inject silicone sealant into the hole
before inserting the screw to seal the hole.
Fix to the pent panel using a 15mm
counter sunk screw (G).
Ø 3.5mmØ 6mm
Pent
panel
When installing the offset enclosure, the brace bar should be xed to the NARROW pent panel.