Step 7
Optional: It is only necessary to t the plastic Anti splash strip (E)
if water splashes out through the gap under the door. Cut the strip
to size (using scissors) and push t onto the lug shown on the
bottom door frame as shown.
Note: If the anti splash strip catches on the door, simply trim to t.
Step 8
Inside
Tray
Sealing outside: Run a line of silicone sealant from top to bottom
down the joint between the wall channels and tiles. Run a line
of silicone sealant 100mm up the joint where the pent panels
slot into the wall channels and pent posts. Run a line of sealant
around the base in the joint between the bottom of the enclosure
and the tray, from wall to wall.
100
mm
Inside
For any further information please contact
Simpsons on: 01483 303711
Or visit our web-site at:
www.simpsons-enclosures.co.uk
The manufacturer reserves the right to make technical
modications without prior notice.
Sealing inside: Run a line of silicone sealant from top to bottom
down the joint between the wall channels and tiles. Run a line of
silicone sealant from top to bottom down the joint where the pent
panels slot into the wall channels and the pent panels and door
slot into the pent posts.
Do not seal the enclosure to the tray on the inside.
InsideInside
To Previous Page
Loading...