Simrad HR22 - User Manual

STBY
TACK
STBY
AUTO
SIMRAD HR22
Fig 1 - HR22 Hand Remote
HR22 Cradle
HR22 Hand Remote
Bulkhead Socket
HAND REMOTE HR22
The HR22 is a remote control for use with the
TP22, TP32 and WP32 cockpit autopilots.
The keypad operates in the same manner as
the autopilot keypad - to engage the autopilot,
press the STBY/AUTO key (Fig 2). The LED
will light, indicating that the autopilot is acti-
vated. To disengage the autopilot, simply press
STBY/AUTO again.
While in Standby mode, the Port ( ) and
Starboard ( ) keys can be used to “power
steer” the vessel using the autopilot (Fig 3).
In Auto mode, press Port ( ) or Starboard ( )
once to alter course by 1º (Fig 4). Press and
hold the key to adjust the course by 10º.
To Autotack, press and hold the TACK key,
and while keeping it held, press Port ( ), or
Starboard ( ) (Fig 5), depending on which
direction the vessel is tacking.
NOTE - If in Sail To Wind mode, the vessel
will tack onto the same apparent wind bearing,
but on the opposite tack. In this mode, the
autopilot will only allow a tack in the correct
direction, and the facility is disabled if sailing
downwind.
NOTE - Access to Nav mode is not available.
STBY
TACK
STBY
AUTO
STBY
TACK
STBY
AUTO
TACK
STBY
TACK
STBY
AUTO
TACK
STBY
TACK
STBY
AUTO
Fig 2 - Engaging Autopilot
Fig 3 - Remote steering to
Port in Standby mode
Fig 5 - Initiating Starboard
Autotack
STBY
AUTO
E04598 Issue 1.0.1 06/04/04
STBY
TACK
STBY
AUTO
Fig 4 - Adjusting course in
Auto mode (1º & 10º)
3-Way Joiner

Simrad HR22 Specifications

General

Brand	Simrad
Model	HR22
Category	Remote Control
Language	English

Summary

Hand Remote HR22 Operation

Engaging Autopilot

Engage and disengage the autopilot using the STBY/AUTO key. The LED indicates activation.

Power Steering and Course Adjustment

Use Port/Starboard keys for power steering (Standby) and 1°/10° course changes (Auto).

Autotack Functionality

Initiate Autotack by holding TACK and pressing Port/Starboard keys. Notes on Sail To Wind mode.

Installation & Wiring

SimNet Connectivity

Connects HR22 to autopilot via SimNet bus using bulkhead socket and three-way joiner.

Power Requirements

12v DC power supply is required for SimNet if not connected to other equipment.