Simrad Naviop Loop M - OP-Box Loop M;M+ Overview; LED indicators; Ethernet wiring

| 11
Installation | Loop M User Manual
OP-Box Loop M/M+
Overview
A
B C
D E F
G
0
A 5-pin Ethernet connector 1, ETH-0
B 5-pin Ethernet connector 2, ETH-1
C Micro-C CAN connector 2, CAN-1 (used for NMEA 2000 network)
D 12-pin Power and Serial connector, PWR/SER
E Micro USB connector, USB
F Micro-C CAN connector 1, CAN-0 (used for Naviop CAN network)
G LED indicators
LED indicators
A B
C
0
LED Status Description
A Power
Off CPU error - no power supply
On Operating mode - operation completed successfully
Flashing slow Error during last operation
Flashing fast Operation in progress
B ETH-0
Off No connection
On / Flashing Connected
C ETH-1
Off No connection
On / Flashing Connected
Ethernet wiring
The OP-Box Loop M/M+ is equipped with two 5-pin Ethernet connectors. The connector
labeled ETH-1 shall be used to connect the OP-Box Loop M/M+ to the Ethernet network.