Simrad Naviop Loop M - Power wiring; USB wiring; Naviop CAN wiring; NMEA 2000 network wiring

12 |
Installation | Loop M User Manual
Power wiring
Power is connected via the Power and Serial connector, labeled PWR/SER.
Only the Red and the Black wire should be used. Unused wires should be folded back and
insulated.
12 V DC
C
D
A
B
A OP-Box Loop M/M+
B Red wire (DC positive) and black wire (DC negative)
¼ Note: Other wires should not be used.
C Fuse, 2A
D 12 V DC power supply
USB wiring
The USB port is used for software updates and system configuration. Refer to “Configuration”
on page 21.
Naviop CAN
The OP-Box Loop M/M+ is equipped with two Micro-C CAN connectors. The connector
labeled CAN-0 shall be used to connect the OP-Box Loop M/M+ to the Naviop CAN network.
NMEA 2000 network
The connector labeled CAN-1 shall be used to connect the OP-Box Loop M/M+ to the NMEA
2000 network.
Egon+ board
!
Warning: For details about maximum load and other specifications,
refer to the “Technical Specifications” on page 30. Exposing the unit to
conditions that exceeds the specifications could invalidate your warranty.