Fly with Remote Controller
Fly with Remote Controller
Pressing and hold will keep dragonfly moving in a 5m radius
orbit around a center at its front. The aircraft head will point to
the center at all times.
During orbit fly, pulling the right stick left or right can make the
orbit larger or smaller.
Pressing H once can stop the orbit-fly mode.
The left dial is used to control the pitch of the gimbal within 90 degree.
The right dial is used to control the yaw of the gimbal within 90 degree.
Orbit Fly
Gimbal control
ON
OFF
90º
ON
OFF
90º
1.Pulling down the left stick will make dragonfly land. Do not push
down too hard or the aircraft may crash on the ground. After
landing, push the left stick to the lowest point and hold it for 5
seconds to shut down the motors.
2.Pressing once will make dragonfly autonomously land at its
current spot. When dragonfly gets close to the ground, it will jump
a few times to find flat base. The motors will stop rotating in 5
seconds after landing on the ground.
In process of landing, it is still available to control position if the
landing area is not flat or safe.
Land
Pressing and hold will make dragonfly autonomously ascend to
15 meters, slowly fly back to the take-off point and land. If there is
obstacle in the way of return-home, it is still available to get control
of dragonfly with the controller.
Return-home only works when the aircraft is 5 meters away from
the take-off point.
Return Home
5m
15 meters
To Next Page
Loading...