Simu 2006029 - User Manual

Hz Digital Keypad Instructions
For use with SIMU Hz radio motors and receivers
Read all instructions carefully before use.
Hz Digital Keypad
®
SIMU Technical Support 800-822-SIMU (7468)
Ref # 2006029
1
Technical Data
 Power supply: 3VDC lithium battery CR 2450
oo oo
 Operational temperature: -5 /140 F (-20 /60 C)
 Enclosure: IP54 (outdoor rated)
 Frequency: 433.42 Mhz
WARNING: Do not allow children to play with the
control system
To insure proper operation, do not install on a metal
surface.
1
3
2
1-PROG: Programming button
2-ADR: Changing radio protocol / Restore
3-RESET: Initializing (power on)
DO NOT
TOUCH
Product Description: The Hz Digital Keypad provides sequencing up/stop/down control of one or two Hz operators or Hz receivers. Control is limited to
authorised users via user selected security codes of 4, 5 or 6 digits.
1 Master code (required): Valid to control both channel buttons and required for all programming operations.
4 Secondary codes (optional): 2 codes can be programmed for each channel button allowing partial access to be given to the property.
Backlighting: Pressing any button will activate back lighting in the event of low light conditions.
2
Installation/Mounting
1) Remove the two allen screws with the provided tool as shown. 2) Pull the top of the face away from the back. 3) Peel cover off foam. 4) Apply the foam to
the back of the keypad case. 5) Mount the back of the case to a vertical wall in the orientation shown. Do not mount to a metal surface.
>2s
3
Programming
44
33
>1s
1) Initialize (power on) the Keypad by pressing the reset for over 2 seconds. This will only need to be done once on a given keypad. 2) Press the programming
button on a transmitter already programmed to the operator for 3+ seconds until the operator jogs. 3) Input the master code (000000 until changed). Press set
and release. 4) Flip the keypad over and press the programming button for over 1 second. The top LED will start blinking 5) Flip the keypad over and press
the desired channel button (1 dot or 2) while the top LED is still blinking. The motor will jog. If a 2nd operator is to be programmed to button 2, repeat steps
2 through 5 with that operator.
PROGRAM BUTTON
22
1/2
55
Use finger or erasure to press PROG, ADR or
RESET button. DO NOT USE a hard or sharp object
Use finger or erasure to press PROG, ADR or
RESET button. DO NOT USE a hard or sharp object

Simu 2006029 Specifications

General

Brand	Simu
Model	2006029
Category	Keypad
Language	English

Summary

Hz Digital Keypad Technical Data and Installation

Technical Data

Provides specifications for power supply, operational temperature, enclosure rating, and frequency.

Installation and Mounting Guidelines

Instructions for physically mounting the keypad, including screw removal and foam application.

Hz Digital Keypad Programming and Operation

Initial Programming Procedure

Steps to initialize the keypad and program a transmitter for operator control.

Changing the Master Code

Procedure to update the primary security code for master access and programming.

Managing Secondary Codes

Instructions for adding, deleting, or deleting all secondary user codes.

Daily Use and Operation

How to use the keypad for daily control, including backlighting and security code entry.

Hz Digital Keypad Troubleshooting and Maintenance

Troubleshooting Common Issues

Guidance on resolving programming errors, incorrect codes, and protocol compatibility.

Replacing the Battery

Step-by-step instructions for safely replacing the device's battery.