SImx UT-T1 User Manual

Heat Transfer Thermostat Initial Setup
Turn off your thermostat with the Power Off Icon.
1. Press and hold the and Icon for 5 Seconds, then release buttons.
2. Press the button until the number in the top right is “04”.
8330NAF = 3 7330NAF = 2 5230NAF = 1 .tik ruoy rof deeps naf eht tes ot sworra dna eht esU .3
Heat Transfer Thermostat User Guide
1. FAN
This displays the Current Fan Speed.
The Heat Transfer model will determine which options are available:
Two Speed Fan – within a Two room heat transfer system. (FAN0337)
= High Speed.
= Low Speed.
= Thermostat will increase Fan Speed automatically.
Three Speed Fan – within a Three room heat transfer system. (FAN0338)
= High Speed.
= Medium Speed.
= Low Speed.
= Thermostat will increase Fan Speed automatically.
Single Speed Fan within a One room heat transfer system. (FAN0325)
= High Speed.
Power ON/OFF
Fan adjust Mode
Mode
Set Temperature Up
Set Temperature Down
Thank you for purchasing this heat transfer system
The touch screen thermostat is pre set to display three fan speeds - High, Medium and Low.
IMPORTANT: If you have purchased a 1 or 2 room (FAN0325/FAN0337) system you will need to set up the controller
before use.
3
1
2
Wait 5 seconds and display returns to normal mode.

SImx UT-T1 Specifications

General

Brand	SImx
Model	UT-T1
Category	Thermostat
Language	English

Summary

Heat Transfer Thermostat Initial Setup

Initial Setup Procedure

Step-by-step guide for initial thermostat setup, including button presses and fan speed configuration.

Fan Speed Configuration

Instructions on setting fan speed based on kit type (FAN0325, FAN0337, FAN0338).

Heat Transfer Thermostat User Guide

Fan Speed Indicators

Explanation of fan speed display and options for three, two, and single-speed fan systems.

Mode and Temperature Settings

Guides on selecting operating modes (Heat Transfer/Ventilation) and setting desired room temperature.

Timer and Lock Functions

Instructions for using the Night Moon Timer and locking/unlocking the thermostat controls.

Configuration Setup Menu

Accessing the programming mode to calibrate settings like temperature correction, fan motor, and air source.