DC INVERTER U-MATCH AIR CONDITIONERS CONTROL
5.3 Field Setting
The centralized controller will display the code of each unit. The unit code is decided by the position
of DIP switch on the wired controller for each air duct (on the back of wired controller). From right to left,
the dial value corresponds to pin 4~1 of the DIP switch. It is “0” if dialed to “ON" and “1” if dialed to “OFF”
on opposite end.
Example 1: If the dial value is “0111”, this represents that the serial number is “8”, the pins 1, 2 & 3
of the DIP switch are dialed to the opposite end of “ON”, and the pin 4 is dialed to “ON”.
Example 2: If the dial value is “1010”, this represents that the serial number is “11”, the pins 2 & 4 of
the DIP switch are dialed to the opposite end of “ON”, and the pin 1 & 3 is dialed to “ON”.
Position Number Position Number Position Number Position Number
0000 1 0100 5 1000 9 1100 13
0001 2 0101 6 1001 10 1101 14
0010 3 0110 7 1010 11 1110 15
0011 4 0111 8 1011 12 1111 16
See below:
Unit Code 1
Unit Code 2
Unit Code 3
Unit Code 4
Unit Code 5
Unit Code 6 Unit Code 7
Unit Code 8
Unit Code 9
Unit Code 10
Unit Code 11
Unit Code 12
Unit Code 13
Unit Code 14
Unit Code 15
Unit Code 16
To Next Page
Loading...
