Sinclair ASGE-18AI - 3 REFRIGERATION PIPING WORK; 3.1 Refrigeration Piping Work Procedures

DC INVERTER U-MATCH AIR CONDITIONERS INSTALLATION
2.5 Installation Clearance Data
Figure 2-5-1
3 REFRIGERATION PIPING WORK
3.1 Refrigeration Piping Work Procedures
1
 Connection Pipe
 The connection pipe must meet the following requirements. The three basic principles are that the
pipe shall be kept dry, clean and no leakage
.
Figure 3-1-1
 Align the flared end of copper pipe with the center of threaded connector and use your hands to
securely tighten the flared nuts.
 Tighten the flared nuts with torque wrench, until you hear a ‘KATA” sound from the torque wrench,
as shown in Fig. 3-1-1. See Table 3-1-1 for the torque required for tightening the nuts.