遥控器各按键的名称及作用
５
Names and functions of wireless remote control
●
Press this button, the unit will be turned
on, press it once more, the unit will be
ON/OFF button
ON/OFF
Remote control
Signal transmitter
AUTO
COOL
DRY
FAN
HEAT
(only for cooling and heating unit)
Don't drop or throw the remote control; Don't let any liquid in the remote control and
Note: Be sure that there are no obstructions between receiver and remote controoler;
Middle fan
turned off. Sleep function will be canceled,
put the remote control directly under the sunlight or any place where is very hot.
while unit off.
●
Press this button, Auto, Cool,Dry, Fan,
Heat mode can be selected circularly.
MODE button
MODE
Auto mode is default while power on.
Under Auto mode,the temperature will not
be displayed; Under Heat mode, the
initial value is 28℃
;Under other
modes,
the initial value is 25℃
．
●
Press this button, Sleep On and Sleep
Off can be selected. After powered on,Sleep
SLEEP button
SLEEP
Off is defaulted. After the unit is turned
off, the Sleep function is canceled. After
Sleep function set up, the signal of Sleep
will display. In this mode, the time of timer
can be adjusted. Under Fan and Auto
modes, this function is not available.
●
Press this button, Auto, Low, Middle, High
speed can be circularly selected. After
FAN button
FAN
powered on,Auto fan speed is default.
Under Blow mode, Low fan speed only
can be set up.
Low fan
High fan
●
Press this button, the clock can be set up,
signal blink and display.Within 5
CLOCK button
CLOCK
seconds, the value can be adjusted by
pressing + or - button, if continuously
press this button for 2 minutes above,
in every 0.5 seconds, the value on ten place
of Minute will be increased 1. During blinking,
repress the Clock button or Confirm button,
signal will be constantly displayed and
it denotes the setting succeeded. After
powered on, 12:00 is defaulted to display
and signal will be displayed. If there is
current time value is Clock value, otherwise
is Timer value.
signal be displayed that denotes the
TEMP button
TEMP
Operation of wireless remote control
（
ｏ
Ｆ）
82
（
ｏ
Ｆ）
77
●
Press this button, can set up and select:
setting temperature (displaying the room),
indoor ambient temperature (displaying
indoor temperature), outdoor ambient
temperature (displaying outdoor tempe-
rature),if there no outdoor ambient
temperature displaying be required that will
keep original display status. and circulate
like this. No signal displayed. Remark: When
operating this button,the setting temperature
is displayed all the time on the wireless
remote control.
To Next Page
Loading...
Need help?
General
