Sinclair KJRM-120H - Timer and Schedule Configuration

8
BACK
CURRENT ERROR CODE
E5
CURRENT ERROR QUERY
TIMER
OK
DATE AND TIME
CANCEL DAILY TIMER
CANCEL WEEKLY TIMER
WEEKLY TIMER
DAILY TIMER
DAILY TIMER
T. O N
00:00 A 00:00 A HEAT 18 C
T. OFF MODE TEMP.ACT
ON
OK
DAILY TIMER
T.
ON
00
:
00
A
00
:
00
A
H
EA
T
18 C
T.
O
FF
MO
D
E
TEMP.
ACT
O
N
O
K
UNIT 07#
ON 00:00 A00:00 A HEAT 18 C
◆ Setting the timer:
Select "TIMER", and press the "OK" button
to enter the interface. The interface display
is as follows:
Select "DAILY TIMER", and press the "OK"
button to enter the interface. The interface
display is as follows:
When the cursor stays at "ACT", press the "▲"
and "▼" buttons to select the parameter value
"OFF" (default value, indicating that the timer
of this segment is invalid) corresponding to
Time1 or Time2, and press the "▲" and "▼"
buttons to adjust the parameter value to "ON"
(indicating that the timer of this segment is
valid); press the "◄" and "►" buttons to select
the start time, end time, mode and
temperature to be set, and then use the "▲"
and "▼" buttons to adjust the time, mode, and
temperature value. After setting, press "OK" to
confirm saving, or press "BACK" to cancel
setting and return to the upper layer page. If
Time1 ON is set the same as Time1 OFF, the
setting is invalid, the ACT option for the timer
of this segment jumps to "OFF", the setting of
Timer2 is the same as that of Timer1, and the
timing interval of Time2 can cross with that of
Time1.