4
3
Names and Functions of indicators on Remote Controller
TRANSMISSION Indicator:
This indicator lights when remote
controller transmits signals to indoor unit.
MODE indicator:
Displays the current operation modes.
Including AUTO( ), COOL( ), DRY( ) ,
HEAT( ) or FAN( ).
HEAT only available for heat pump model.
TEMPERATURE indicator:
SWING indicator:
This indicator lights up when the SWING
button is pressed.
FAN SPEED indicator:
Displays the selected fan speed, AUTO( ) and
three fan speed levels LOW( ), MED( ),
HIGH( ). Displays (flashing) when the
operating mode is either AUTO or DRY.
TIMER indicator:
The time set for timer operation is indicated.
(0.5 ~ 24 hours)
NOTE: All items are shown in the Fig.2 for the purpose of clear
presentation But during the actual operation only the
relative functional items are shown on the display panel.
Display Panel
Fig. 2
1
2
3
4
5
7
Operating the Remote Controller
When the Air Conditioner is ready for use, switch on the power
and the OPERATION indicator lamp on the display panel of the
indoor unit starts flashing.
1. Use the Mode select button to select AUTO.
2. Push the or button to set the desired room temperature.
The most comfortable temperature settings are between 21 C
to 28 C.
3. Push the On/off button to start the air conditioner. The OPE-
RATION lamp on the display panel of the indoor unit lights. The
operating mode is AUTO. The FAN SPEED is automatically
controlled.
4. Push the On/off button again to stop the unit operation.
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote controller to
malfunction.
2. If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the
indoor unit or if the Transmission Indicator light fails to appear.
1. In the AUTO mode, the air conditioner can logically choose
the mode of COOL, FAN, HEAT and DRY by sensing the dif-
ference between the actual ambient room temperature and
the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you , the desired mode
can be selected manually.
Install / Replace Batteries
AUTOMATIC OPERATION
NOTE
NOTE
Hr.
ON TIMER
Hr.
Off TIMER
SET TEMP
Auto
22
66
77
55
44
33
Displays the temperature settings(17 to 30 ).
SLEEP/TURBO indicator:
Each time the Sleep/Turbo button is pushed, the
signal displays in the following sequence:
6
Auto
Use two alkaline dry batteries (R03/LR03X2).
Do not use rechargeable batteries.
(1) Remove the battery cover by pulling it according to the
arrow direction.
(2) Insert new batteries making sure that the
(+) and (-) of battery are installed correctly.
(3) Reattach the cover by sliding it back into position.
Turbo
Turbo
Nothing
Nothing
Nothing appears when the operating mode is either
DRY or FAN only
To Previous Page
Loading...