Singer 66-18 - Page 13

11
threa.i on the
spool
pin
(1)
and
pass
thc thread fronr
the
spool
pin
into
the thread
guide
(2),
then
dorvn
and to
thc right into thc lorver notch of the
bobbin
rvinder thread
guide (3)
at
the
front of the machine
bcd, then around the
back
of this
guide
and into its
upper
notch,
then up and through the
hole in
the
left sidc of thc bobbin
(4)
from thc
inside.
Prcss tlic
bobbin rvinder
puiley
(5)
down against the
hub
of the
balance whcel. Press
the
knee controller or depress
thc foot eontroller as lor soving.
The
end of the thread must be hold by hand
until a feu. coils a,r'e
rvountl and slxrultl then
be
broken off.
l'ig.
5 shorvs the bobbin
rvinder
properly
thrcadcd
and in
position
for rvinding. \\'hen suflftcicnt
thread
has
been s'ound upon the
bobbin,
pull
the
bobbin l-inder
pulley
au'ay from the halance
wheel
and
remove the bobbin from the spindle.
If the thread
does not u.ind evenly on the
bobbin,
loosen the
screu. r,r-hich holds
the bobbin s'inder
thread
guide (3)
in
position
on the bed
of the
ma-
chine, and turn
this
guide
to tho
right
or left, as
may
be
rcquired,
thcn tighten the screw.