Singer 66-18 - Page 56

51
edge of the
ruffle
to
the right
of the attachment
as slio$'n
in Fig.
56.
The material for
piping
must measure
abotl
1r.1
inch
wide when folded
in the centcr and is usuallv
cut on the bias. Place
the
piping
material in
the
rufficr, follorving
the linc 4, in Fig.
52, rvith the
folded edge
of the
piping
to
the
right.
Thc matcrial
to rvhich the
piping
and
ruffiing
are to be
serrn
should
be folded
on the edge
and inserted in the
rufficr, folloiring
the linc
i,
in
Fig.
52.
To
Adjust
the Ruffier
for Plaiting
Raise the adjusting lever
(E,
Fig.
57) and move
it to thc right
so that the
projection (D,
Fig.
57)
Frc.
57
will enter the slot
marked
"6"
in the adjusting lever
whcn
the lever is releascd.
The ruffiing
blade will
then move
lorsurd
and bnek once at everv six
stitchcs. To
adjust the ruffiing
blade to
-uk"
a
plait
once at
every tll.eive
stitches,
place
the adjust-
ing lcver
(E,
Fig.
57) so that
the
projection
(D)
cntcrs
the slot markcd
"72"
in
the adjusting levcr.
Insert
thc material
to
be
plaited
betlr.een the
two
blue blades,
foliou'ing
thc line
(2,
Fig.
52). Thc size
orrvidth
of
plaits
is regulated
by
the adjusting scre$'