Oil Points – Just a cou
le dro
s now
don’t over do it.
Basic Service (continued):
Return to Table of Contents
13. Ok, we’ve got the machine opened up. Blow all the lint out of the Bobbin Case area, Bottom Pan area, and Needle Bar area.
14. Give the machine one to two drops of oil wherever you see metal against metal. If it moves and it’s not a plastic or rubber
item, give a couple drops of oil. Again, do not oil the gears, drive belt, or motor area.
I know, I said not to oil Plastic parts area, but give the
main shaft a drop or two here. If metal is against
metal, a couple drops. Especially the main shaft,
where it goes through the bushings of the machines
casting.
To Next Page
Loading...
