10. Thread the looper eye (A) from front to back. Pull about 4 inches of thread.
Position thread into V cutout (B) on threader. Firmly hold thread tail with left
hand and pull Threader lever (C) up into place (D).
Thread Right Overedge needle with regular overlock thread
.
1. Raise the Presser Foot to release the tension disks. Thread the right
needle as illustrated 1-9.
2. Pass thread from back to the front
through the thread guide .
Threader Lever
“V” cutout
Four-Thread Ultra-Stretch Mock Safety Stitch page 11
NOTE: Make sure the Upper Looper
thread is behind the Lower Looper
thread.
To Next Page
Loading...
