16
OPERATING INSTRUCTIONS….cont
Step 1:
Turn the main engine switch to the on (1) position.
Step 2:
Slide the fuel tap to the on position (see below, left).
Engine Switch
Note: The choke may not be needed if the engine is already warm or the
ambient temperature is hot.
Fuel Tap
Choke
Step 3:
Slide the choke lever to the left (see above, right).
13
OPERATING INSTRUCTIONS….cont
Flammable: The fuel used to run this pressure washer (unleaded petrol) is
highly flammable. Never re-fuel the pressure washer whilst it is running. Do
not re-fuel near naked flames or other possible ignition sources.
Caution: Ensure the oil level is maintained; Failure to do so will invalidate
any warranty you may have.
FILLING THE PUMP WITH OIL / CHECKING THE OIL LEVEL
Note: The pressure washer is shipped with oil in the pump, but the level
should be checked prior to operation.
Note: If the oil needs to be topped up / replaced, 85w90 oil should be
used.
To check the oil level; look at the sight glass on the side of the pump - The oil should
be level with the middle of the sight glass.
If the oil level is low; Unscrew the filler bung and slowly pour 85w90 oil into the pump
until it is at the correct level.
Refit the filler bung.
FILLING THE PRESSURE WASHER WITH FUEL
Filler Bung
Sight Glass
Fill Level
To Next Page
Loading...
Need help?
General