Table of contents Sirona Dental Systems GmbH
Gebrauchsanweisung und Installation
4
64 08 137 D3610
D3610.201.02.09.0211.2017
5.4
Enabling exposure readiness....................................................................... 70
5.5
Sliding the hygienic protective sleeve over the sensor ................................ 73
5.6
Position the sensor ...................................................................................... 74
5.6.1
Position sensor with single-use sensor holder system .................. 75
5.6.1.1
Notes on the sensor holder tabs................................... 75
5.6.1.2
Anterior tooth exposure ................................................ 75
5.6.1.3
Posterior tooth exposures............................................. 77
5.6.1.4
Bite wing exposures ..................................................... 78
5.6.1.5
Endodontics exposures with the half-angle technique . 79
5.6.1.6
Measurement exposure for endodontics ...................... 80
5.6.2
Position sensor with Aimright reusable sensor holder system....... 81
5.6.2.1
Anterior tooth exposure ................................................ 81
5.6.2.2
Posterior tooth exposures............................................. 85
5.6.2.3
Horizontal bite wing exposures..................................... 88
5.7
Select the exposure parameters for the X-ray tube assembly ..................... 91
5.7.1
X-ray doses and image quality....................................................... 91
5.7.2
Recommended dose for XIOS XG sensors ................................... 91
5.7.3
HELIODENT Plus exposure times ................................................. 92
5.7.3.1
Pre-programmed exposure times for XIOS XG
sensors with 200 mm (8") FHA cone............................ 92
5.7.3.2
Pre-programmed exposure times for XIOS XG
sensors with 300 mm (12") FHA cone (round or
square cone)................................................................. 93
5.8
Releasing the exposure ............................................................................... 94
5.9
Removing the hygienic protective sleeve from the sensor........................... 95
5.9.1
With single-use sensor holder system ........................................... 95
5.9.2
With Aimright reusable sensor holder system................................ 97
5.10
Alignment of the X-ray image....................................................................... 98
5.11
Resend non-transmitted WiFi exposures to SIDEXISXG / SIDEXIS 4 ....... 99
6
Maintenance and inspection ................................................................................... 101
6.1
Hygiene........................................................................................................ 101
6.1.1
Care, cleaning agents, and disinfectants....................................... 101
6.1.2
WiFi interface, charger and sensors .............................................. 101
6.1.3
Sensor holders............................................................................... 102
6.2
Regular inspections ..................................................................................... 103
6.3
Replace the sensor cable ............................................................................ 104
6.4
Replace the WiFi interface storage battery.................................................. 106
7
Consumables and spare parts................................................................................ 108