Siruba 747L User Manual

特別事項 WARNING
為了避免機器故障及損壞，請先確定以下
事項：
1. 當您安裝好機器後，做第一次機器操作
前，請徹底清潔機器。
2. 清除運送途中累積之灰塵及溢出之油
脂。
3. 確定電壓及馬達相數 ( 單相或三相 ) 安
裝正確。
4. 確定電源插頭正確地接上電源。
5. 當使用電壓與標示電壓不同時，請勿使
用機器。
6. 確定機器轉動方向是否正確。
警告：
在操作或調整本書中所提到之各步驟
前，請先將電源關掉，以免因為機器突
然啟動造成之意外。
Please conrm the followings to avoid
malfunction or damage to this machine.
1. After installing the machine, and before
the rst operation, please clean it
completely.
2. Clean all dust and overowed oil during
transportation.
3. Conrm that the voltage and the phase
(single or 3 phase) of motor are set
correctly.
4. Conrm that the power plug is correctly
connected to the power supply.
5. Never use the machine when the
local voltage type is different from
the marked voltage on the nametag
attached on the machine.
6. Conrm that the rotating direction of
the machine pulley is correct.
Warning:
Before doing any operation or any
adjustment described later in this
manual, please turn the power off to
prevent accidents caused by abrupt
start of the sewing machine.
P7
Introduction

Siruba 747L Specifications

General

Brand	Siruba
Model	747L
Category	Sewing Machine
Language	English