Siruba DT8200 Series User Manual

Siruba DT8200 series
Contents
1. Installation Introduction .................................................................... 1
1.1 Product specifications ..................................................................... 1
1.2 Interface connection ...................................................................... 1
2 Operation Panel Instruction. ............................................................. 4
2.1 Operation panel display instruction ............................................... 4
2.2 The operation panel keys of description… .....................................5
3 System parameter setting ................................................................. 9
3.1 Technician mode ........................................................................... 9
3.2 Administrator mode ..................................................................... 14
3.3 Monitoring Mode .......................................................................... 20
3.4 Safety switch warning mode ........................................................ 20
3.5 False alarm mode ........................................................................ 21
4 Special function operating instructions ........................................ 22
4.1 Upper stop position adjust ........................................................... 22
4.2 A key recovery machine manufacturers parameter value ........... 23
4.3 Pedal sensitivity adjustment ........................................................ 23
4.4 Electromagnet performance adjustment ...................................... 24
4.5 Start/ end back tacking sewing mode set .................................... 25
4.6 Start/ end back tacking sewing and Four-segment sewing is set long
needle ................................................................................................ 26
4.7 H-70 operating panel count needle number / piece number function
27
i

Siruba DT8200 Series Specifications

General

Lubrication	Automatic
Type	Overlock
Number of Needles	2
Number of Threads	4
Motor	Servo Motor

Summary

Safety Instruction

Installation Introduction

Product Specifications

Details on product type, supply voltage, power frequency, and maximum output power.

Interface Connection

Instructions for connecting foot pedal and other components to the controller.

Power Connection and Grounding Basic Parameters

Guidance on system grounding engineering and AC input power connection for safe operation.

Operation Panel Instruction

Operation Panel Display Instruction

Explains LCD module display of sewing patterns, parameters, and status.

Operation Panel Keys Description

Details the function and appearance of each key on the operation panel.

System Parameter Setting

Technician Mode

Procedure to enter technician mode and modify the parameter table with password.

Administrator Mode

Instructions for entering administrator mode and modifying parameters using password.

Monitoring Mode

How to enter monitor mode for real-time parameter monitoring.

Safety Switch Warning Mode

Lists alarm codes, their meanings, and solutions for safety switch issues.

False Alarm Mode

Troubleshooting steps for system errors or warnings, including error codes and solutions.

Special Function Operating Instructions

Upper Stop Position Adjust

Procedure to reset the needle position in the control system after factory recovery.

A Key Recovery Machine Manufacturers Parameter Value

Steps to restore factory parameters using a single key recovery function.

Pedal Sensitivity Adjustment

Guidance on adjusting pedal movement for sewing speed regulation and sensitivity.

Electromagnet Performance Adjustment

Details on adjusting parameters for No. 1, 2, and 3 electromagnets for optimal performance.

Start/ End Back Tacking Sewing Mode Set

How to switch between single, double, four, and none back tacking sewing modes.

Start/ End Back Tacking Sewing and Four-Segment Sewing is Set Long Needle

Setting start/end back tacking and four-segment sewing modes with needle number adjustment.

H-70 Operating Panel Count Needle Number / Piece Number Function

How to set and display count needle number or piece number using the H-70 operating panel.