Siruba VC008 VSQ - ADJUST THE ORNAMENTAL PUSHING ROD; Height and Clearance Adjustment

I
·-- - --- -- - ----------------- - -- -- -- ----- - ---- - - - - -- -- ------------- - -- ---------- - - - -- - -----)
~M:M ta:o~a N-~~~~ ADJUST THE ORNAMENTAL I
=1Dtii1PHKm4FFR~11P1 PUSHING ROD !
--- -- --- -- - ----- - - ----- - --- --- ~- ------- ~ ~-- ---- ----- - - - - ---- - - _____ _ J
1. 1: 1'7!11-!i
,, > ~••u•n~~~<DJlimWtt~ooB9
8EIUlHili13-15 mm • flli!R!I!IM®
(1116)
(2) :it•J:&«tfl!XB9.tftififl~@ · ~
00 1fU~ 1' a~ ~ijl Ji 00 J: a ~0. 2 m mf.J 110
~~~~-~~D·~•w~aoo••
· Rifli*litfU~@B<Jpqil~W~9~it\ll!6
1. 5- 2. 0 mm (1117)
(3) 'l:~tfli·tt~pqil!JaM~&t~A~ti&
•~tt~•~••*•~~·~m••
8M®~J.1~(?)1lLKOO.trfiMtt~ft
ti~~ ~rm lt'i-~ l1i.l CftPlflrra=b)fl~m
SUI**® (118)
(4) ~RtfUitt~~~i!i11£1'·a~ · ~~
~11SI**®1l~~ifliMW~Ji1i~fg
0. 2 mmlHl~tf~ltiUII**® o (118)
(5) ~Jf;~J:~trUitt~© · ® • ®:tt~
~-@~-15 · ~~~ffU~!!e"iiJ~I
lbMfi · J:l'~fdl1'~•fl:t:::k o
-12-
1. Adjust the height
(1} Adjust the distance to 13- 15 mm
between the bottom surface of
Ornamental pushing rod base(f) and
needle plate surface. Then
please
tighten the screw®.(Fig . 6)
(2} Assemble the lowest ornamental
pushing rod@ and make the
gap
0.2 mm between the bottom surface of
ornamental pushing rod and the upper
surface of presser foot. So it can move
smoothly and not have friction with the
presser foot. By the way, the distance
between
ornamental pushing rod@
inner side and
needle outer side is
1.5 mm-2.0 mm. (Fig. 7)
(3) When the line of ornamental pushing
rod inner side and the line between
right and left needle of needle clamp
is
Parallel, please loosen the screw®
and adjust the base(?) in order to make
the distance between ornamental
Pushing rod and left or right needle be
the same
(It means parallel a= b). Then
please tighten the
screw® . (Fig.B}
(4) When the ornamental pushing rod is
not flat, please adjust the two
screws®
in order to keep the difference in
0.2 mm between the ornamental
pushing rod and presser foot. Then
please tighten the
screws®.(F ig. B)
(5) Assemble the ornamental pushing rod
in sequence©,® . ® . Follow the key
point to assemble@. Please make sure
if the rods can be moved fluently. The
friction between upper and lower rods
should be
small.
From the library of: Superior Sewing Machine & Supply LLC