SISTEM AIR TECNO Series

Questions and Answers

K
khowardAug 14, 2025
What to do if the dust bag is full in my SISTEM AIR Vacuum Cleaner?
- G
  gwoodwardAug 14, 2025
  If the dust bag of your SISTEM AIR Vacuum Cleaner is full, replace it with a new one.
X
xnelsonAug 18, 2025
What to do if the power cable is unplugged on my SISTEM AIR TECNO Vacuum Cleaner?
- R
  Ryan LongAug 18, 2025
  If your SISTEM AIR Vacuum Cleaner isn't working, check the power cable and connect it properly.
L
Leslie WalterAug 21, 2025
What to do if the flexible hose or cleaning accessories are broken on my SISTEM AIR TECNO?
- T
  tiffanyvaldezAug 21, 2025
  If the flexible hose or cleaning accessories of your SISTEM AIR Vacuum Cleaner are broken, check them for damage and replace if necessary.
M
Michael WilliamsAug 25, 2025
What to do if the start button is on OFF position of my SISTEM AIR TECNO Vacuum Cleaner?
- C
  Christina StevensonAug 26, 2025
  If your SISTEM AIR Vacuum Cleaner is not starting, make sure the start button is pressed to the ON position.
M
Manuel GonzalezAug 27, 2025
Why is my SISTEM AIR Vacuum Cleaner losing suction when multiple sockets are in use?
- H
  Howard HernandezAug 28, 2025
  Ensure that only one suction inlet is used at a time on your SISTEM AIR Vacuum Cleaner. Avoid using the service suction socket simultaneously.
C
charles73Aug 31, 2025
What to do if the micro line cable is not connected to my SISTEM AIR Vacuum Cleaner?
- B
  Brandi RichardsonAug 31, 2025
  If the micro line cable of your SISTEM AIR Vacuum Cleaner is not connected, connect the activation cable (sensor).
A
Andrew MilesSep 3, 2025
What to do if depression of the system is low (90/100 mbar) in my SISTEM AIR Vacuum Cleaner?
- R
  Robert SuttonSep 3, 2025
  If the depression of the SISTEM AIR Vacuum Cleaner system is equal to or lower than 90/100 mbar, check for possible losses in the system and reduce the opening time of the vacpan inlet.
T
Tracy MirandaSep 7, 2025
What to do if there is no suction from SISTEM AIR Central Vacuum Systems?
- S
  stephanievargasSep 7, 2025
  If your SISTEM AIR Central Vacuum System has no suction from any of the suction sockets, there might be several reasons. First, ensure the power cable is properly connected. Then, check if the start button is in the OFF position and press it to turn it on. Also, verify that the micro line cable (activation sensor) is connected. If the motor's thermal protection has been activated, allow a few minutes for the motor to cool down. Finally, check if the overcurrent circuit breaker has tripped and manually reset it.
A
Amanda PerezSep 10, 2025
Why does my SISTEM AIR Central Vacuum Systems show a filter alarm with a clean filter?
- H
  Heather JohnsonSep 10, 2025
  If you're experiencing a filter alarm with a clean filter cartridge in your SISTEM AIR Central Vacuum System, it could be due to a system depression equal to or lower than 95 mbar. Check for possible losses in the system. Also, try reducing the opening time of the vacpan inlet.