Safety Rules for Digital Angle Finder
Warning: avoid sharp edges. Be careful in handling, may cause laceration.
Caution: the angle finder is a precision measuring instrument. Dropping or
banging the device may result in impaired function or future inaccurate
readings.
Technical Data
Measuring range --------------------------------------------------- 0° to 220°
Measuring accuracy
Angle ------------------------------------------------------------- ±0.5°(9mm/m)
Spirit Level ------------------------------------------------------ ±0.029°(0.5mm/m)
Lowest indication unit --------------------------------------------- 0.1°
Operating temperature -------------------------------------------- 0℃ - 50℃
Storage temperature ----------------------------------------------- 20℃ to 85℃
Battery ----------------------------------------------------------------- 1 x 9V (Not Included)
Operating lifetime --------------------------------------------------- Approx. 50h
Automatic switch – Off after approx -------------------------- 5 min
Leg to leg length --------------------------------------------------- 450 mm
Weight according to EPTA-Procedure 01/2003 ------------ 1.1lb
Preparation
INSERTING/REPLACE THE
BATTERY (FIG. 2)
Use only 9V battery
To open the end cap/battery lid (10),
remove two screws and pull out end cap.
Insert the battery onto terminal and re-install
end cap and screws.
● When the LOW BAT (battery) indicator (b)
appears in the display for the first time,
measurements are still possible but accuracy
may be reduced, please replace battery.
● IF THE MEASURING TOOL IS NOT USED
FOR A LONG PERIOD OF TIME, THE
BATTERY MUST BE REMOVED. The
To Next Page
Loading...