Need help?Do you have a question about the Sitech GCS900 and is the answer not in the manual?
Configure initial display settings and GNSS accuracy limits.
Adjust text items and configure specific view settings.
Configure advanced display options and enter operator name.
Navigate menu to Blade Wear and measure from cutting edge bolts.
Avoid bolt at tip, enter distance, and return to screen.
Navigate menu to select design and highlight file.
Press ESC to return to the operating screen.
Position machine at bench point and verify blade tip selection.
Verify Northing, Easting, Elevation and consult supervisor.
Access offset menu and enter vertical offset value.
Confirm offset and view its display on screen.
Navigate to Horizontal Offset screen.
Set alignment and select line offset.
Enter offset distance, select left/right, and change blade direction.
Navigate menu to change guidance method and accept.
Press ESC to return to the operating screen.
Configure mapping settings and softkeys.
Navigate to display Cut/Fill map and scale.
Focus on lane and press F3 for lane guidance.
Use F3 to turn Lane Guidance Off and ON.
Navigate menu to calibrate sensors and select blade slope sensor.
Follow instructions, finish, and return to screen.
Navigate menu to connectivity settings and select Wi-Fi network.
Enter pass phrase, press F6, finish, and return to menu.
Navigate menu to connectivity and community settings.
Enter device password, organization, and confirm settings.
Navigate menu to remote assistant configuration.
Enter support number, force upgrade, and return to screen.
Navigate menu to connectivity and wireless data sync.
Press F1 to start sync and ESC to return.
Navigate menu to select Remote Assistant.
Press F1 to start, check connection icon, and return.
Navigate to base configuration, select IBSS-Remote Base, and create new.
Select base, review name, and confirm connection.
General| Brand | Sitech |
|---|---|
| Model | GCS900 |
| Category | Construction Equipment |
| Language | English |
To Next Page