Advanced
This tab allows you to set the advanced wireless options. The options included are
Channel Bandwidth, Fragment Threshold, RTS Threshold, Beacon Interval, and Preamble
Type. You should not change these parameters unless you know what effect the changes
will have on the router.
Fragment Threshold Set the Fragment threshold of wireless radio. The default
value is 2346.
RTS Threshold Set the RTS threshold of wireless radio. The default value is
2347.
Beacon Interval Set the beacon interval of wireless radio. The default value is
100.
DTIM Period Set the DTIM period of wireless radio. The default value is 3.
Data Rate Set the wireless data transfer rate to a certain value. Since
most wireless devices will negotiate with each other and pick
a proper data transfer rate automatically, it’s not necessary
to change this value unless you know what will happen after
modification.
Channel Width Select wireless channel width (bandwidth taken by wireless
signals of this access point). It’s suggested to select ‘Auto
20/40MHz’. Do not change to ’20 MHz’ unless you know what
it is.
To Next Page
Loading...
