When you do a print job again. The control center will automatically do a
connecting operation on printing again. This is so-called “Auto Connect /
Disconnect” operation.
Note: Under the “Auto-Connected Printer” setting, it is not necessary to manually press
the “Connect” button when printing. If you press the “Connect” button for printing,
please make sure to click “Disconnect” button after you finish the printing. Otherwise,
other users cannot print properly. It is because you are the only ownership of the
connected printer.
AutoRun
You can make the Control Center be run automatically after you login Windows. To do
this, you choose the “Configuration” item in the “Tools” menu. The following window will
appear. Click the check box and then on the “OK” button. This feature is enabled by
default.
To Next Page
Loading...
Need help?
General
