8 Bringing up the WLR-3001
Connect the supplied power-adapter to the power inlet port and connect it to
a wall outlet, or switch the router on without the power adapter connected to
work off the battery. The WLR-3001 automatically enters the self-test phase.
During self-test phase, the Power LED will be lit continuously to indicate that
this product is in normal operation.
9 Initial Setup of the WLR-3001
LOGIN procedure
1. OPEN your browser (e.g. Internet Explorer).
2. Type http://192.168.0.1 in the address bar and press [Enter].
To Next Page
