46
Add Special Application Fill in the "Trigger Port", "Trigger Type”, “Public
Port”, "Public Type", "Public Port" and "Comment" of the setting to be added
and then click "Add". The Special Application setting will be added into the
"Current Trigger-Port Table" below. If you happen to make a mistake, just
click "Clear" and the fields will be cleared.
Delete If you want to remove Special Application settings from the "Current
Trigger-Port Table", select the Special Application settings you want to
remove in the table and then click "Delete Selected". If you want remove all
Special Application settings from the table, just click the "Delete All" button.
Click "Reset" will clear your current selections.
To Next Page
Loading...
