Page 7
CHAPTER 3:
INSTALLATION AND LOCATION GUIDE:
The machine must be installed in an environment in which the temperature does not
exceed 30 degrees Celsius.
!
The machine should be fixed horizontally to a solid brick wall by the bracket
provided using all the ten plugs to spread the load of the unit evenly. Other
options are a stand which should be fixed to the wall, or a special wall bracket
which will enable fixing onto Bessa brick walls. After the bracket or stand has
been fastened to the wall, make sure that it is stable, as the machine weighs
140Kg when full. Position t he electric control unit in a location where no
water is likely to splash on it and away from direct sunlight.
!
Position the machine in a location where there is adequate ventilation (airflow)
ie. not in a recess in the sealing and not in front of airconditioner inlet/outlet.
as the machine produces heat and requires air circulation to remain cool. i.e.
not in recesses where the air cannot circulate around the machine.
!
If the water cooler is to be placed in the ceiling, please ensure that there is easy
access for cleaning, maintenance removal if necessary and service. (Any cost
incurred in removing from, and reinstalling t he water chiller in the ceiling
cavity is not covered by warranty.)
!
Ensure that the area where the machine is to be installed is a clean, dust free
and free of vermin.
Follow the diagram in the chapter 6 “ INSTALLATION AND FINAL TEST” for
correct positioning and location.
!
Connect the machine to a source of drinking water with a maximum pressure
of 3 bars. POLLUTED WATER SHOULD NOT BE USED IN ANY
INSTALLATION. DO NOT USE HOT WATER.
!
For Electrical connection see chapter 6.
!
The machine is designed to cool (or heat in models “N”) drinking water.
!
The machine should be used by an operator who must have read through this
manual.
To Next Page
Loading...
