sitrex TR/11 - Introduction and Warranty Information; Manual Overview; Manufacturers Warranty Policy

1
Introduction
This manual includes full instructions for the correct use and maintenance of the
machinery, and also the recommended spare parts list.
In order to prevent any possible damage or injury to the machine and/or the operator(s),
read this manual carefully for proper knowledge of the assembly of the implements, their
use in the field, and their maintenance. If you have any doubts, please contact your local
dealer or distributor.
Should the machine be resold, please supply this manual along with the machine to the
new purchaser.
Warranty
The manufacturer warrants new machinery to be free from defects in materials and
workmanship at the time of delivery to the original purchaser if correctly set up and
operated according to this Operator's Manual.
The manufacturer will repair or replace free of charge any defective part which is returned
by the purchaser (freight prepaid) and found to be defective on inspection authorized by
the manufacturer during the warranty period.
This warranty shall be valid for 12 (twelve) months from the delivery of the goods to the
original purchaser.
If the customer is unable to return the defective part to the manufacturer, the manufacturer
cannot be held liable for any costs due for repair or replacement of any part of the
machine. The manufacturer shall only supply the part(s) required for such repair and/or
replacement.
The warranty shall be considered null and void when it is evident that the machine has
been improperly used or has been repaired without authorization.
The manufacturer shall not be held liable for any obligation or agreement reached by any
employers, agents or dealers who do not comply with the above warranty. The
manufacturer cannot be held liable for the subsequent damages. This warranty replaces
any other warranty, either explicit or implied, as well as any other obligation of the
manufacturer.
NOTE:
ALL WARRANTY WORK OR REPAIRS MUST BE APPROVED BY THE
MANUFACTURER BEFORE WORK BEGINS. ANY WORK OR REPAIRS MADE
BEFORE APPROVAL MAY NOT BE COVERED UNDER WARRANTY.
PLEASE NOTIFY YOUR SALES & SERVICE DEPARTMENT OF THIS POLICY.
TABLE OF CONTENTS:
1) GENERAL INSTRUCTIONS
2) GUIDE TO THE SIGNS AND SYMBOLS
3) PRODUCT IDENTIFICATION
4) DELIVERY AND ASSEMBLY INSTRUCTIONS
5) INSTRUCTIONS FOR WORK AND TRANSPORT
6) GENERAL MAINTENANCE INSTRUCTIONS